Alinco DR-510 User Manual

The ALINCO DR-510T/510E, 2m
FM Dual Band Mobile Trans-
ceivers have been specially
designed to condense maximum
performance and operating. con-
venience into an ultra compact
package. An impressive array of
features give maximum flexibility
in mobile installations.
High Output Power
The DR- 510T/510E provide a power-
ful 45Watts on 2m and 35Watts on
70cm. A HI/LO power switch 5 watt
low power selection on both bands
as well.
Compact Size and Lightweight.
140(W)x50(H)x205(W)mm (5-l/
2”x2”x8-l/16”) at 1.7KgsJ3.74 Ibs)
Cross Band Full Duplex Operation.
14 Multi Function Memory Chan-
nels.
The unit contains 14 fully program-
mable Memory Channels. Each
channel stores operating frequency,
Standard offset and other usefull
information.
Highly Visible LCD.
A new multi color LCD display for
improved visibility.
6 Channel Spacing steps.
for ease of operation 5, 10, 12.5, 15,
20 and 25 KHz.
4 Scanning Modes.
(a) VFO -Scanning of the entire band.
(b) Memory -Scanning of selected
memories.
(c) Programmed Band-Scanning of a
selected segment of the band.
(d) Priority Scanning-Allows selection
of a frequency, in VFO or Memory,
to serve as a priority frequency.
Restricted Access Operation.
allows for programmable encode/
decode sub-audible tones(DR-510T)
or a 1,750Hz tone burst function(DR-
510E).
Microphone
The standard microphone offers:
(A) UP/DOWN buttons for ease of
frequency/Memory selection.
(B) An LED “ON AIR” indicator and
“LOCK” switch to enable/disable
microphone func$ion(DR-5lOE)
(C) DTMF Encoder built-in.(DR-510T)
Duplexer Built-in
When antenna for both bands(VHF&
UHF) is in use only one cable for
transceiver is necessary.
Other Outstanding
Features :
oFunction Lock Key
l Reverse Key-Inverts TX-RX
l Memory Skip
l Odd Offset
l Multiple Standard Offsets
l 0ther too numerous list.
Accessories supplied
as standard :
o Hand Microphone(Condencer type)
a. 16 button DTMF Microphone(DR-
510T) b. Hand Microphone(DR-510
E)
l Mobile Mounting Bracket
l Mounting Hardware
l D.C. power Cable

Alinco DR-510 Specifications

Frequency and Modulation

frequency range (U.S. Version)	144.00-147.995 MHz
frequency range (Europe)	430-440 MHz
frequency resolution	5, 10, 12.5, 15, 20 and 25 kHz steps

Power

power supply requirement	13.8 Volts D.C.
current drain (receiving)	does not exceed 500 mA at 13.8V
current drain (transmitting)	9.5 A at VHF, 10 A at UHF

Transmitter

transmitter power output (VHF)	High: 45 Watts
transmitter power output (UHF)	High: 35 Watts
modulation system	Variable Reactance F.M.

Audio

audio power output	More than 15 Watts (8 ohms - 10% Distortion)
speaker impedance	8 ohms
microphone type	Electret Condenser Microphone

Weight and Dimensions

weight	1.7 Kgs
height	50 mm
depth	205 mm

Summary

ALINCO DR-510T/510E Transceiver Features

High Output Power

Provides powerful 45W on 2m and 35W on 70cm with HI/LO power switch for flexible output.

Compact Design and Operation

Features compact size, lightweight, cross-band full duplex, and 14 memory channels for flexible installation.

Advanced Display and Scanning

Offers a highly visible multi-color LCD, 6 channel spacing steps, and 4 scanning modes for enhanced usability.

Microphone and Connectivity

Includes UP/DOWN microphone, DTMF encoder, built-in duplexer for single antenna use, and other features.

ALINCO DR-510T/510E Specifications

General Specifications

Covers frequency coverage, resolution, antenna impedance, power supply, and dimensions of the transceiver.

Transmitter Specifications

Details output power, emission mode, modulation system, frequency deviation, and spurious emissions.

Receiver Specifications

Outlines receiving system, modulation acceptance, intermediate frequency, sensitivity, and selectivity.

Front Panel and LCD Layout

Identifies controls on the front panel and indicators on the LCD for user interface navigation.