Alinco DR-510E - Specifications; General Specifications; Transmitter Specifications; Receiver Specifications

SPECiFICATIONS
■ General
Frequency Coverage 144.0~148.0MH2(DR-510T)
440.0-450.0 MHz
144.0-146.0 MHz (DR-510E)
430.0-440.0 MHz
Antenna Impedance 50 ohms unbalanced
Power Supply
Requirement 13.8 Volts D.C.
Current Drain all 3.8 V — Receiving
Squelched: does not exceed 500 mA
Transmitting
High: 45 W approx. 9.5 A at VHF
35 W approx. 10 A at UHF
Lew: 5 W approx. 4 A at VHF
5 W approx. 4 A at UHF
Dimension 140 mm (W) x 50 mm (H) x205 mm (D)
(5y2"x2"x8yi6")
Weight Approx. 1.7 kgs. (3.75 ibs.)
■ Transmitter
Output Power High; 45 Watts at VHF, 35 Watts at UHF
Low; Approx. 5 Watts at both bands
Emission Mode 16F3
Modulation System Variable Reactance F.M.
Max. Frequency Deviation .. ±5 kHz
Spurious Emission More than 60 dB below carrier
Microphone Electret Condenser Microphone
Operating Mode Simplex
Duplex: ±600 kHz from receive frequency at VHF
: ±5,1.6,7.6 MHz from receive frequency at UHF
(Odd Offsets programmable)
DTMF Encoder Built-In
■ Recelver
Receiving System Superhetrodyne, dual conversion
Modulation Acceptance — 16F3
Intermediate Frequency Ist 10.7 MHz 2nd 455 kHz at VHF
Ist 30.825 MHz 2nd 455 kHz at UHF
Sensitivity 12 dB SINAD less than 0.16 pV
Selectivity More than ±6 kHz at -6 dB
Less than ± 12 kHz at -60 dB
Audio Power Output More than 1.5 Watts (8 ohms-10% Distortion)
Speaker Impedance 8 ohms
- 3 -