Alinco DR-510E - Scanning Modes; Programmable Scan; Memory Scan

Select the desired Memory
Channel using the Main Dia! or
the microphone UP/DOWN
buttons.
Press the MW key during the
"M" Indicator is flashing.
If the "flashing stops betöre
the MW key is pressed, you
must press F key again in
Order to complete the desired
function.
■ SCAN
The following scan options are avail-
able:
Program Scan (Limited Frequency
Coverage in one band only)
Memory Scan
VHF or UHF Band scan
A. Programmable Scan
The scan frequency is determined
by the frequencies stored in Mem
ory Channels A and B.
The frequency stored in Memory
Channel A and B must be different
frequencies.
Betöre pressing the SCAN key,
adjust the SQL control to the
threshold level.
1. Determine the desired scan fre
quency ränge and enter the fre
quencies into Memory Channel
A and B.
2. Press the VFO/M key to select
the VFO mode, and also select
the band of the stored frequen
cies.
3. Press the SCAN key to intitate
scan.
4. To clear scanning, press the
SCAN key or the microphone
P.T.T. Switch.
B. Memory Scan
1. Press the VFO/M key to select
the Memory Channel mode.
2. Betöre pressing the SCAN key,
adjust the SQL control to the
threshold level.
3. Press the SCAN key to initiate
scan.
4. To clear scanning, press the
SCAN key or the microphone
P.T.T. switch.
-10-