Alinco DR-510E - Display Indicators

UHF
Display
0 O 0 O
ri n _
u u m8
000©
REV + - OUAL ENG DEC PRt rCAUT
«J 3 3 n ri „ ^
[Jn3TcgJ=fscW=,.yOViR -0
T
0
O REV (Reverse) Indicator
Tums on when the reverse function
has been selected.
© Shift and Dual Indicators
"+" or indicator turns on during
repeater offset operations. See
page 13. "DUAL" indicator tums on
during Dual Operation. See page
14.
0 ENG (Encoder) indicator
Turns on to indicate that ENCOD-
ING TONE function is active.
O DEC (Decoder) indicator
Tums on to indicate ttie DECODER
(CTCSS) function is active.
0 PRI (Priority) Indicator
Turns on to indicate the PRIORITY
function is active.
O CALL Indicator
Tums on to indicate the CALL func
tion is active.
O Frequency display
Displays the transmit/receive fre
quency, Frequency Step, or Tone
Frequency.
O Decimal point indicator
Separates the MHz, and kHz.
Flashes in Scan mode. Disappears
in Memory skip mode.
© BUSY indicator
On whenever the squelch is open or
Signal is received.
© S/RF Meter
This meter indicates the relative
receive input Signal strength and
relative transmitter RF Output.
© ON AIR Indicator
Tums on during transmit opera
tions.
© M (Memory) indicator
Turns on whenever the transceiver
is in the Memory mode. Flashes to
indicate programming in process.
© Memory Channel Number
display
Indicates the selected memory
Channel Number.
-6-