17
(17)
CH Color A
Set color for the band A channel display.
(18)
CH Color B
Set color for the band B channel display.
(19)
Zone Color A
Set color for the band A zone display.
(20)
Zone Color B
Set color for the band B zone display.
(21)
Main Ch
Channel A: The upper displayed channel will be set to become the main
channel.
Channel B: The lower displayed channel will be set to become the main
channel.
(22)
Sub Ch On/Off
Sub Channel On: Turns on the sub channel, and the radio will display
both channel.
Sub Channel Off: Turns off the sub channel, and the radio will display the
main channel only
(23)
SMS Notify
Different prompt options when receive a new message.
(24)
Call Ring
Different prompt options when receive a new call.
(25)
Freq Step
2.5K,5K,6.25K,10K,12.5K,20K,25K,30K,50K, total of 9 frequency steps.
(26)
Ana SQ Level
Adjusts the squelch level to receive signal with
different signal strength, and a total of 5 levels offered.
This function is only valid for analog channel.
(27)
TBST Sel
TBST frequency is used to activate some dormant repeaters, 1000Hz,
1450Hz,1750Hz, 2100Hz a total of 4 options are offered.
Hold pressing PTT key, at the same time press UP or DN key on
microphone to transmit the TBST tone.
(28)
Scan Mode
SCM TO: When scanning and stopping for a signal, stays at the channel
5s before resuming the scan.
SCM CO: When scanning and stopping for signal, stays at the channel
until the signal disappears, and resumes scan 2s later.
SCM SE: When scanning and stopping for a signal, will terminate the
scan. This function is only valid for a VFO scan.
(29)
Mic Level
Allows to adjust the Microphone gain, level 1 is the lowest, level and 5 is
highest gain.
(30)
DTMF Speed
Offers DTMF encode speed which will help the receiver decode
successfully, 50~500ms are the options.
(31)
AM/FM Radio
Off: AM or FM function is off.
FM Mode: Turn on FM radio.
AM Mode A: Turn on AM function,the AM channel will default at band A
in display.
AM Mode B: Turn on AM function,the AM channel will default at band B
in display.
(32)
FM Radio Moni
Radio Mon On: When FM radio is used, you can still receive or transmit
on the channel.
Radio Mon Off: When FM radio is used, the radio will not permit a
transmission or reception.
(33)
Start Up Pwd
On: Set up the password for start up. You need to input the password to
power on the radio.
Off: No password is required for the radio power on start up.
7
MAIN MENU FUNCTIONS
To Next Page
Loading...
