Why I cannot change Programming Code on Allegion Door locks?
This can happen because: 1. '3' was not pressed after entering Programming Mode. 2. Second Programming Code entered did not match first Programming Code entered. 3. First 4 - 6 digits of new Programming Code match an existing User Code.
Why I cannot delete all User Codes on Allegion SCHLAGE CONNECT Door locks?
This can happen because: 1. '6' was not pressed after entering Programming Mode. 2. The 2nd Programming Code entered was not valid.
Why backlighting does not come on when Outside Schlage button is pressed and User Code cannot be entered on Allegion SCHLAGE CONNECT?
This can happen because: 1. Batteries are completely dead and no electronic operations are possible. 2. The battery tray is not connected. 3. The cable that runs through the door is not connected. Remove the Alarm Assembly and check the connection.
What does it mean when after entering a User Code to unlock the Allegion SCHLAGE CONNECT Door locks, the yellow dot is flashing and there is a delay before unlock?
The battery is low and should be replaced.
What does 3 Red when Outside Schlage Button is pressed on Allegion SCHLAGE CONNECT Door locks mean?
The battery is critical and must be replaced.
General| Brand | Allegion |
|---|---|
| Model | SCHLAGE CONNECT |
| Category | Door locks |
| Language | English |
Details the product's mechanical, finish, and electronics warranty terms.
Procedure for locking the deadbolt from the exterior.
Procedure for unlocking the deadbolt from the exterior.
Explains various programming functions and their effects.
Steps to turn the lock's alarm system on and off.
Details the different alarm modes, lights, and sounds.
To Next Page
