35
THE ALL PATCH
Between patch 127 and 0 is a special patch function called
ALL This lets you overwrite all 128 patches with the current
console mute settings. You would normally do this before
programming the patches for a particular show. Typical use would
be :
Turn all mutes off in all patches (clear), then edit the mutes
on for required channels.
Turn all mutes on in all patches (set), then edit the mutes
off for required channels.
Turn unused channel mutes on before editing the used
channels.
Turn mostly muted channel mutes on before editing the
patches where they are not muted.
Note that the ALL function overwrites all 128 patches and
should be used with care. A confirm function is included to
prevent accidental operation.
OVERWRITE ALL 128 PATCHES
Operate the mutes to set up the console as required. You
may wish to start by clearing or setting all mutes as decribed
previously.
Scroll
∧∧
∧∧
∧ or
∨∨
∨∨
∨ until the display shows ALL
Press STORE
The red LED and the display both flash to warn that all
patches will be overwritten.
Press any other key to cancel or
Press STORE again to confirm the overwrite function.
The display scrolls automatically through all 128 patch
numbers as the patch memory is overwritten.
)
To Next Page
Loading...
Need help?
General
