Need help?Do you have a question about the ALLEN & HEATH Xone:22 and is the answer not in the manual?
Connections - Inputs| phono RCA connection impedance | 47K/330pF |
|---|---|
| line RCA connection impedance | 20K ohm |
| FX RTN RCA connection impedance | 10K ohm |
| mic XLR connection impedance | <2K ohm |
Connections - Outputs| main mix balanced XLR output impedance | 68 ohms |
|---|---|
| monitor RCA output impedance | 68 ohms |
| record RCA output impedance | 600 ohms |
| FX SND RCA output impedance | 47 ohms |
Performance| distortion | 0.002% THD+N |
|---|---|
| noise | -84dBu un-weighted |
| frequency response | 10Hz to 30kHz +0/-3dB |
Weight and Dimensions| weight | 2.2 kg |
|---|---|
| packed weight | 3.5 kg |
Details the terms and conditions for the product warranty.
Adjusts input signal level and switches between Phono/Line sources.
Controls frequency bands and monitors the signal level per channel.
Engages filter/FX loop and adjusts the music level for each channel.
Activates FX loop and sets master/monitor output signal levels.
Adjusts filter resonance, type (LPF/HPF), and cut-off frequency.
Sets headphone volume and selects headphone monitoring source (cue/master).
Pans between channels, selects crossfader curve, and chooses meter display.
Fades signal level between the two channels, response set by curve switch.
Details line, phono inputs, and main, monitor, record, headphone outputs.
Connects external effects units and the power supply unit.
Terminal for connecting turntable ground wire to minimize hum.
Professional XLR mic input with EQ and level adjustment.
1/4" jack output for connecting headphones.
Explains voltage-controlled filter, high-pass, and low-pass filter effects.
Discusses normal operating range, headroom, signal-to-noise, and dynamic range.
Warns against high listening levels and ear fatigue effects.
Explains earthing for safety from shock and audio performance.
Provides advice on mains system, turntables, cables, and connections.
Instructions for replacing worn faders and crossfader.
Guide to modifying jumper settings for phono-to-line conversion.
Steps to diagnose and resolve issues with no audio output.
Troubleshooting steps when the external effects unit is not heard.
Diagnosing and fixing issues with loud or distorted audio signals.
Details input/output connections, impedance, levels, and performance metrics.
Provides physical measurements and weight of the mixer.
Instructions for registering the product's serial number and user details.
To Next Page
