14 POINT I/O Dual Port EtherNet/IP Adapter
Publication 1734-IN040C-EN-P - December 2018
WARNING: When used in a Class I, Division 2, hazardous location, this
equipment must be mounted in a suitable enclosure with proper wiring method
that complies with the governing electrical codes.
WARNING: If you connect or disconnect wiring while the field-side power is
on, an electrical arc can occur. This could cause an explosion in hazardous
location installations. Be sure that power is removed or the area is
nonhazardous before proceeding.
WARNING: Do not wire more than two conductors on any single terminal.
WARNING: To comply with the CE Low Voltage Directive (LVD), this equipment
must be powered from a Safety Extra Low Voltage (SELV) or Protected Extra Low
Voltage (PELV) compliant source.
To Next Page
Loading...
Need help?
General
