4 Rockwell Automation Publication 1769-IN015D-EN-P - October 2017
Compact I/O End Caps/Terminators
European Hazardous Location Approval - 1769-ECR, and 1769-ECRK
European Zone 2 Certification (The following applies when the product bears the Ex or EEx Marking)
This equipment is intended for use in potentially explosive atmospheres as defined by European Union Directive 2014/34/EU and
has been found to comply with the Essential Health and Safety Requirements relating to the design and construction of Category 3
equipment intended for use in potentially explosive atmospheres, given in Annex II to this Directive.
Compliance with the Essential Health and Safety Requirements has been assured by compliance with EN 60079-15 and EN 60079-
0.
WARNING:
• This equipment must be installed in an enclosure providing at least IP54 protection when
applied in Zone 2 environments.
• This equipment must be used within its specified ratings defined by Allen-Bradley.
• Do not disconnect equipment unless power has been removed or the area is known to be
nonhazardous.
ATTENTION: This equipment is not resistant to sunlight or other sources of UV radiation.
To Next Page
Loading...
Need help?
General
