CompactLogix Controller 5
Rockwell Automation Publication 1769-IN082C-EN-P - February 2013
European Hazardous Location Approval
European Zone 2 Certification (The following applies when the product bears the Ex or EEx Marking.)
This equipment is intended for use in potentially explosive atmospheres as defined by European Union Directive 94/9/EC and has
been found to comply with the Essential Health and Safety Requirements relating to the design and construction of Category 3
equipment intended for use in potentially explosive atmospheres, given in Annex II to this Directive.
Compliance with the Essential Health and Safety Requirements has been assured by compliance with EN 60079-15 and EN
60079-0.
WARNING:
• This equipment must be installed in an enclosure providing at least IP54 protection when
applied in Zone 2 environments.
• This equipment shall be used within its specified ratings defined by Allen-Bradley.
• Provisions shall be made to prevent the rated voltage from being exceeded by transient
disturbances of more than 40% when applied in Zone 2 environments.
• Secure any external connections that mate to this equipment by using screws, sliding latches,
threaded connectors, or other means provided with this product.
• Do not disconnect equipment unless power has been removed or the area is known to be
nonhazardous.
ATTENTION: This equipment is not resistant to sunlight or other sources of UV radiation.
Allen-Bradley Parts
To Next Page
Loading...
Need help?
General
