CompactLogix Controller 11
Rockwell Automation Publication 1769-IN082C-EN-P - February 2013
Minimum Spacing Requirements
When using any of the CompactLogix packaged controllers, maintain spacing from enclosure
walls, wireways, and adjacent equipment. Allow 50 mm (1.97 in.) of space on all sides, as shown.
This provides ventilation and electrical isolation.
Install the Battery
Complete these steps to install the battery on your packaged controller.
1. Open the battery door on the left side of the packaged controller.
2. Carefully attach the battery connector to the port located inside the packaged controller.
3. Insert the battery, wires down, in the slot on the battery door.
WARNING: When you connect or disconnect the battery an electrical arc can occur. This could
cause an explosion in hazardous location installations. Be sure that the area is nonhazardous
before proceeding.
For Safety information on the handling of lithium batteries, including handling and disposal of
leaking batteries, see Guidelines for Handling Lithium Batteries, publication AG 5-4.
CompactLogix L23
OK
BATT
I/O
DCH 0
FORCE
RUN
50 mm
(1.97 in.)
50 mm
(1.97 in.)
50 mm
(1.97 in.)
50 mm
(1.97 in.)
Allen-Bradley Parts
To Next Page
Loading...
Need help?
General
