Allen-Bradley PowerFlex 700S Installation Instructions

Publication 20D-IN027A-EN-P
PowerFlex 700S Power Jumpers
Frames 1…6
Installation Instructions
The PowerFlex 700S drive contains protective MOVs and Common Mode
Capacitors referenced to ground (see below). To guard against unstable
operation and/or damage, the drive must be properly configured
as shown in
Table A on page 2
.
Important: All PowerFlex 700S drives, frames 1…6, are shipped with
the DC
bus common mode capacitors referenced to ground.
For additional general information, refer to:
Title Publication Available Online at …
PowerFlex 700S Phase II Drives, Frames 1…6
Installation Instructions
20D-IN024 www.rockwellautomation.com/
literature
Wiring and Grounding Guidelines for PWM AC Drives DRIVES-IN001
Guarding Against Electrostatic Damage 8000-4.5.2
DC+
DC–
R/L1
S/L2
T/L3
MOV and AC EMI Capacitor Phase to Ground
Common Mode Capacitor to Ground
Jumper-Wire
Jumper-Wire

Allen-Bradley PowerFlex 700S Specifications

General

Model	PowerFlex 700S
Input Voltage	200-240V AC, 380-480V AC
Power Range	0.75-250 kW (1-350 HP)
Control Method	Sensorless Vector Control, Vector Control
Communication Options	EtherNet/IP, ControlNet, DeviceNet
Enclosure Type	IP20, IP30, NEMA/UL Type 1, 12
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Relative Humidity	5% to 95% (non-condensing)
Altitude	Up to 1000 m (3300 ft) without derating
I/O	Digital and Analog I/O