Allen-Bradley PowerFlex 700S - Page 31

Rockwell Automation Publication 20D-TD002L-EN-P - July 2018 31
PowerFlex 700S Drives with Phase II Control
Single-phase Input Power
PowerFlex 700S drives are typically used with a six-pulse, three-phase input supply. However, single-phase operation is
possible under certain conditions as explained below:
AC Input Phase Selection (Frames 5 and 6 Only)
Moving the “Line Type” jumper (shown in the illustration below) will select single or six-pulse, three-phase operation.
Remove plastic guard to access jumper.
Fan Voltage Selection (Frames 5 and 6 Only)
Frames 5 and 6 utilize a transformer (located behind the power terminal block) to match the input line voltage to the
internal fan voltage. If your line voltage is different than the voltage class specified on the drive nameplate, it may be
necessary to change the transformer taps.
Frames 5 & 6 Jumper and Transformer Locations
Frames Condition
1…6 Not currently rated under the UL508C listing. Rockwell Automation has verified that single-phase operation with output current that is derated by 50% of the six-pulse, three-phase
ratings that are listed in the tables beginning on page 51 will meet all safety requirements.
9…14 Listed by UL to operate on single-phase input power with the requirement that the output current is derated by 80% of the six-pulse, three-phase ratings listed in the tables
beginning on page 51.
IMPORTANT When selecting single-phase operation, input power must be applied to the R (L1) and S (L2) terminals only.
W R R 14-1 0 W (2.5-35
2
)
R 32 - B (3.6 - )
R P 0.67 (17 )
75 W R
PWR R R
W R R 6-1 0 W (16-35
2
)
R 44 -B(5 -)
R P 0.83 (21 )
R D R R (P )
300 D PWR P R (P P -)
W R R 22-10 W (0.5-4
2
)
R 5.3 - B (0.6 - )
R P 0.35 (9 )
17
21
PP
ti na
ni ati n
e
9
480 Volt Tap
600 Volt Tap
690 Volt Tap
400 Volt Tap
400 Volt or 600 Volt Tap
480V or 690 Volt Tap
LINE
TYPE
SPARE 1
SPARE 2
3-PH 1-PH
Line Type Jumper
Fan Voltage Selection
(Frame 5 shown)
Older drives Newer drives