Allen-Bradley PV550 User Manual

Publication 2711-UM014B-EN-P
11-6 Installing the PV1400 Terminal
5. Install the 10 mounting clips (3 on top, 3 on bottom, 2 on each
side). The ends of the clips slide into slots on the
terminal.Tighten the clip mounting screws hand tight.
6. Alternately tighten the mounting clip screws until the terminal is
held firmly against the panel. Tighten mounting screws to a
torque of 10 inch-pounds. Do not over-tighten.
Install 10 Mounting Clips
= Recommended
Placement of
Mounting Clips
Keypad Version
Touch Screen
Version
ATTENTION
!
Mounting nuts must be tightened to a torque of
10 inch-pounds to provide a proper seal and to
prevent potential damage to the terminal.
Allen-Bradley assumes no responsibility for
water or chemical damage to the terminal or
other equipment within the enclosure because
of improper installation.

Allen-Bradley PV550 Specifications

General

Brand	Allen-Bradley
Model	PV550
Category	Touch terminals
Language	English