Rockwell Automation Publication 42EF-UM001A-EN-P - September 2015 17
Setting up the 42EF for IO-Link Mode
Chapter 4
Setting up the 42EF for IO-Link Mode
This chapter shows the physical hardware and software required to configure the
42EF through IO-Link and provides a simple guide to setting up the hardware.
Products required:
Hardware
• 42EF RightSight sensor
• CompactLogix™ or ControlLogix® PLC Platform
• POINT I/O™ Communications Interface: 1734-AENTR
• POINT I/O IO-Link Master Module: 1734-4IOL
• POINT I/O Terminal Base: 1734-TB
• RJ45 network cable for EtherNet/IP connectivity:
1585J
-M8TBJM-1M9*
• 889D cordsets (optional): 889D-F4AC-5** (IO-Link maximum
acc
eptable cable length is 20 m (65.6 ft))
Software
• Studio 5000 environments, version 20 and higher
• Sensor specific IODD
• 1734-4IOL IO-Link Add-on Profile (AOP)
To Next Page
Loading...