What to do if my Allen + Roth Indoor Fireplace has no power?
If your Allen + Roth Indoor Fireplace has no power, first ensure the power cord is securely plugged into a standard 120V outlet. Then, check that the unit is powered on.
Why doesn't the remote control for my Allen + Roth Indoor Fireplace work?
If the remote control for your Allen + Roth Indoor Fireplace isn't working, the most likely cause is a weak or failing battery. Replace it with 1 CR-2025 battery.
What does Error E2 mean on Allen + Roth Indoor Fireplace?
If your Allen + Roth Indoor Fireplace displays error code E2, it indicates that the thermostat sensor is broken or not working correctly. Unplug the unit and wait 15-20 minutes for the sensor to reset. Plug it back in and turn on the heater. If the problem persists, call customer service. Note that other functions besides the heater should still work.
Why is the Allen + Roth Indoor Fireplace remote control signal weak?
If the remote control signal for your Allen + Roth Indoor Fireplace is weak or intermittent: - Press the buttons slowly and steadily. - Move closer to the insert, ensuring you are within 20 feet and 45 degrees to either side from the front of the fireplace insert, as the remote control's range is limited. The cause of this problem may be a weak or failing battery or using the remote control too far away or at an off angle.
How to fix no flame effect on Allen + Roth Indoor Fireplace?
If your Allen + Roth Indoor Fireplace is powered on but there is no flame effect: - Make sure the flame effect is not powered off by pushing the flame brightness button until the desired level is achieved. - Ensure the USB cable is connected into the USB port behind the Fireplace Grate.
Why does the power cord of my Allen + Roth Indoor Fireplace get warm?
It is normal for the power cord of your Allen + Roth Indoor Fireplace to get warm during operation because heaters require more current. Check the connections of the appliance cord and the outlet, ensuring the plug fits tightly. During use, check the plug and outlet frequently; if they are HOT, discontinue use and consult a qualified technician to check or change the overheating outlet(s).
Why does the fan motor continue to blow after I power off my Allen + Roth Indoor Fireplace?
It is normal for the fan motor of your Allen + Roth Indoor Fireplace to continue blowing after the unit is powered off. This is a standard feature that allows the blower to cool off the heater tubes.
How to fix Error E1 on Allen + Roth Indoor Fireplace?
If your Allen + Roth Indoor Fireplace displays error code E1, it means the overheat sensor has been engaged. To resolve this, unplug the unit and wait 15-20 minutes to allow the sensor to reset. Then, plug it back in and turn on the heater. If the problem continues, contact customer service. Note that other functions besides the heater should still work.
Steps for replacing the battery in the remote control when it becomes weak or unresponsive.
Information on proper disposal and recycling of used batteries according to environmental guidelines.
General| Model Number | 2267FM-28-201 |
|---|---|
| Brand | Allen + Roth |
| Category | Indoor Fireplace |
| Voltage | 120V |
| Fuel Type | Electric |
| Adjustable Thermostat | Yes |
| Remote Control | Yes |
| Overheat Protection | Yes |
| Material | Metal and Glass |
To Next Page
