To Next PageTo Next PageWhat to do if there is low water flow in my Allen + Roth Plumbing Product?
If you're experiencing low or no water flow, make sure both water supply valves are fully open. Turn both water supply valves counterclockwise to the on position.
Why is my Allen + Roth Plumbing Product leaking or dripping after turning it off?
If your Allen + Roth Plumbing Product is leaking or dripping after being turned off, it could be due to grommets not sealing properly or misplacement of temperature limit stops. Replace the cartridge and reinstall the temperature limit stops over the cartridge stem, ensuring the round pit on the stem faces upward.
How to fix reversed hot and cold water on Allen + Roth Plumbing Product?
If the hot and cold water are reversed, the lines may be reversed, or the cartridge might be installed upside down. Rotate the cartridge stem 180° so that the notch is facing down towards the drain.
What to do if water comes out of tub spout and showerhead at same time on Allen + Roth Plumbing Product?
If water comes out of both the tub spout and showerhead simultaneously when turning on your Allen + Roth Plumbing Product, and if the leak from the tub spout is less than 0.01 GPM when the water flow switches to the shower, it is a normal occurrence. Otherwise, ensure the pipe is 1/2 in. IPS or COPPER. Relocate the showerhead or valve to ensure the minimal distance of 49 in. Remove the tub spout and flush out debris and/or replace the undersized line or fittings. Remove the valve and reinstall in the proper orientation.
Why is there only hot or cold water coming from my Allen + Roth Plumbing Product?
If you are only getting hot or cold water from your Allen + Roth Plumbing Product, the balancing spool might be stuck. Replace the cartridge.
General| Brand | Allen + Roth |
|---|---|
| Model | 2564458 |
| Category | Plumbing Product |
| Language | English |
Addresses potential noise and water hammer issues in PEX plumbing systems.
Details essential preparation steps and guidelines before product assembly and installation.
Details thin and thick wall installation procedures for proper valve placement and support.
Explains slipped and threaded installation methods for the tub spout component.
Provides instructions for cleaning and maintaining the faucet's finish and components.
