4
Operation
Getting Started
It is necessary to first fully charge the Battery Pack as described below and to have a few
electronic identification ear tags or implants available for testing. It is very important to
carry out the three steps described in this section before using the reader (see “
Battery handling instructions” section for more information)
Step 1: Installing the battery pack in the device.
Insert the battery in the reader. The pack is keyed for proper
installation.
The stationary key should be up towards the display. The
battery pack will “snap” into place when it is properly
inserted. DO NOT FORCE the battery into the reader. If the
battery does not insert smoothly, verify it is properly
orientated.
Step 2: Charging the battery pack.
Unscrew the protective cap which guards against foreign
material contamination.
Insert the data-power cable by engaging the connector and
rotating the lock-ring.
Plug the power cord into the cable socket located at the end of
the data-power cable.
To Next Page
Loading...
