54 M413487
Section 6 Adjustments
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the tumbler before servicing.
• Close gas shut-off valve to gas tumbler before servicing.
• Close steam valve to steam tumbler before servicing.
• Never start the tumbler with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the tumbler is properly grounded.
W002
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
73. CYLINDER BELT TENSION
NOTE: To find the proper tension, apply light
thumb pressure midway between the cylinder
sheave and the step pulley, and adjust until the belt
can be depressed approximately 1/2 inch (13 mm).
a. Support corner drive guard and remove screws
holding corner guard to rear of tumbler.
b. Support drive guard cover and remove screws
holding guard to rear of tumbler.
c. Loosen the four jackshaft assembly attaching
screws. Refer to Figure 29.
d. Loosen adjusting nuts on outer eyebolt and
rotate bottom nut clockwise until proper
tension is reached. Refer to Figure 28.
e. Retighten all nuts and screws.
f. Readjust drive belt.
IMPORTANT: Adjusting the cylinder belt tension
WILL AFFECT the drive belt tension. You MUST
check and readjust the drive belt tension after
adjusting the cylinder belt tension.
74. FAN BELT TENSION
Refer to Figure 30.
NOTE: To find the proper tension, apply light
thumb pressure midway between the fan motor
pulley and the fan pulley, and adjust until the belt
can be depressed approximately 1/2 inch (13 mm).
a. Support corner drive guard and remove screws
holding corner guard to rear of tumbler.
b. Support drive guard cover and remove screws
holding guard to rear of tumbler.
c. Loosen the two mounting bracket attaching
screws.
d. Raise or lower eye bolt until proper tension is
reached.
e. Retighten all nuts and screws.
Figure 29
T317PE1B
JACKSHAFT
ASSEMBLY
JACKSHAFT
ASSEMBLY
ATTACHING
SCREWS
Figure 30
T213SE1A
FAN
BELT
FAN
PULLEY
MOUNTING
BRACKET ATTACHING
SCREWS
EYE
BOLT
FAN
MOTOR
PULLEY
To Next Page
Loading...
