To Next PageTo Next Page
Need help?Do you have a question about the Alliance Laundry Systems DTB50CG and is the answer not in the manual?
General| Brand | Alliance Laundry Systems |
|---|---|
| Model | DTB50CG |
| Category | Dryer |
| Capacity | 50 lbs |
| Heat Source | Gas |
| Voltage | 120/240 V |
| Phase | 1 |
| Amperage | 15 A |
| Type | Commercial |
| Control Type | Microprocessor |
Essential safety precautions for operating the tumbler to prevent hazards.
Details model applicability and conversion table for measurements.
Illustrates where to find model and serial numbers on the tumbler.
Provides contact details for obtaining literature or replacement parts.
Guide for inspecting the tumbler upon delivery for any shipping damage.
Lists essential local materials for gas, electric, and steam tumbler connections.
Instructions on how to safely move, place, and level the tumbler for installation.
Guidelines for tumbler enclosures, clearances, floor, layout, and venting.
Specifies floor load capacity and preparation for tumbler installation.
Recommendations for tumbler placement, airflow, and exhaust ducting.
Crucial warnings regarding gas connections, fire, and explosion risks.
Illustrates gas loop and supply piping configurations and sizing for different capacities.
Guidelines for determining correct steam pipe sizes based on pressure and length.
Procedures for installing steam solenoid valves, traps, and condensate lines.
Essential warnings and instructions for safe electrical connections and grounding.
Guidance on setting jumpers for different voltage configurations (OPL Micro Control Models).
Instructions for installing a ring ferrite to protect electronic controls from electrical disturbances.
Detailed electrical requirements, wire sizes, and breaker ratings for various tumbler models.
Procedure for adjusting the air shutter for optimal combustion and flame pattern.
Steps to adjust the air flow switch for proper tumbler operation and safety.
How to adjust the door switch and strike for proper door closure and safety shutoff.
Step-by-step guide for operating the manual dual timer tumbler through a drying cycle.
Instructions for operating coin-operated and OPL tumblers, including cycles and controls.
Explanation of the reversing feature and how to use the reverse control switch.
Daily procedure for cleaning the lint screen and compartment to ensure proper airflow.
Scheduled maintenance tasks including lubrication, lint removal, belt tension, and overall checks.
Addresses problems related to airflow, venting, gas pressure, and burner adjustments.
Troubleshooting input voltage, back draft damper operation, and general tumbler issues.
