Alliance Laundry Systems LTEE5ASP433AW12 - Igniter Glows but Burner Does Not Ignite - Gas Dryer Models

34 806221
Dryer Control Troubleshooting
16. Igniter Glows But Burner Does Not Ignite – Gas Dryer Models
Gas dryer models: Igniter glows but
burner does not ignite.
Did sensor
fail in closed
position?
Replace sensor.
Yes
Is secondary
coil or holding
coil open?
No
Is gas supply
insufficient?
Check gas
supply and
pressure. Make
sure gas shut-
off valve is
turned on.
No
Yes
SWD1697S
Replace gas
valve (in
warranty) or
replace coils
(out of
warranty). Refer
to Dryer Test
Procedures
section.
Yes
Are igniter
and bracket
improperly
installed on
burner tube
assembly?
Loosen screw and
properly position
igniter and bracket
on burner tube
assembly.
Is sensor
improperly
installed on
burner
housing?
Loosen screw
and properly
position the
sensor on the
burner housing.
No
Yes
Yes
No