Display Identification
Light Emitting Diodes (LEDs)
(Refer to Figure 1 )
Light Emitting Diodes (LEDs) are used to indicate the chosen cy-
cle, cycle status, when the bleach compartment is dispensing, and
door lock information. See below for information on each LED.
WASH LED
Wash LED is lit at the beginning of a wash portion of the cycle
and will remain lit until the wash is complete.
RINSE LED
Rinse LED is lit at the beginning of a rinse portion of the cycle
and will remain lit until the rinse is complete.
SPIN LED
Spin LED is lit during the final spin portion of the cycle.
DOOR LED
Door LED is lit whenever the door is locked. The door can’t be
opened when this LED is lit.
BLEACH LED
Bleach LED is lit when bleach compartment is dispensing for the
first time in the cycle.
7-Segment Digits
The 7-Segment Digits are used to display the time remaining in a
cycle, error messages and descriptive codes. During diagnostic
testing or manual programming of the control, these digits will
display descriptive codes and values (as described in Entering the
Manual Mode).
Display Identification
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
11 Part No. F8237801ENR13
To Next Page
Loading...
