Preliminary Information
About the Control
This control is an advanced, programmable computer that lets the
owner control most machine features by pressing a sequence of
keypads. Refer to Figure 1 .
The control allows the owner to program custom cycles, retrieve
audit information, and other programmable features. Refer to
Programming the Control for a list of features. Machines shipped
from the factory have a default cycle built in. However, the own-
er can change the default cycle, or any cycle, as needs permit.
The default cycle is #5.
IMPORTANT: In the event of a power failure, the control
will not have to be reprogrammed. It is designed with a
memory system that will remember how it was pro-
grammed until the electrical power is restored.
IMPORTANT: It is extremely important that the machine
has a good ground connection and that all mechanical
and electrical connections to the control are made be-
fore applying power to or operating the machine.
Glossary of Terms
The following are a few terms and abbreviations to learn. These
are referred to throughout the instructions.
Display – This term refers to the window area of the control that
displays words and values.
LED (Light Emitting Diode) – This term refers to the lights next
to the keypads and status words of the control.
Power Failure Recovery
If a cycle is in progress and the power fails for less than five (5)
seconds, the cycle status is saved in memory. When the power re-
covers, the machine will resume into the previously active cycle.
If the length of the power failure is greater than five seconds, the
control will end the cycle and the display will revert back to Start
Mode.
Communications
The control may be programmed manually or by infra-red com-
munication with an external device.
Infra-red Communications
An external device, such as a PDA, allows the owner to program
and retrieve information from the control without touching the
keypad. An external device greatly expands the programming op-
tions available to the owner. However, the external device is not
required to program and operate the machine. The operation of an
external device and the advanced features available are covered
separately in the instructions included with the external device
software. Contact Alliance Laundry Systems for a list of ap-
proved PDAs and other external devices.
Preliminary Information
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
9 Part No. F8237801ENR13
To Next Page
Loading...
