EasyManua.ls Logo

Alliance Laundry Systems UDEE5BGS173CW01 User Manual

Alliance Laundry Systems UDEE5BGS173CW01
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
www.alliancelaundry.com
Troubleshooting
DRY684C
DRY726C
Part No. D515518ENR2
June 2018
Homestyle
Dryers
Refer to Page 6 for Model Numbers

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Alliance Laundry Systems UDEE5BGS173CW01 and is the answer not in the manual?

Alliance Laundry Systems UDEE5BGS173CW01 Specifications

General IconGeneral
BrandAlliance Laundry Systems
ModelUDEE5BGS173CW01
CategoryDryer
TypeElectric
Voltage240 V
Amperage30 A
Capacity7.0 cu. ft.
ColorWhite
Control TypeElectronic
Temperature Settings4
Drum MaterialGalvanized Steel
Reversing ActionYes
Wrinkle Prevention OptionYes
End of Cycle SignalYes
Door ReversalYes
Energy Star CertifiedNo

Summary

Section 1 Safety Information

Section 3 Troubleshooting

Dryer Motor Does Not Run

Step-by-step guide for diagnosing a dryer with a non-functioning motor.

Dryer Stops in Cycle; Burning Smell; Cycles on Thermal Protector

Troubleshooting steps for dryers that stop mid-cycle or exhibit specific symptoms.

Motor Runs, Cylinder Does Not Turn

Procedure to diagnose a dryer where the motor operates but the cylinder is stationary.

Dryer Motor Does Not Stop

Steps to troubleshoot a dryer motor that fails to shut off.

Dryer Runs Only When Door is Open

Diagnosing why the dryer operates solely when the door is open.

Heating Assembly Does Not Heat or Burner Does Not Ignite

Troubleshooting steps when the dryer's heating system fails to operate.

Igniter Does Not Glow (Gas Supply Sufficient)

Diagnosing igniter issues in gas dryers when gas supply is adequate.

Burner Ignites and Goes Out Repeatedly (Gas Models)

Troubleshooting for gas dryers where the burner cycles on and off erratically.

Igniter Glows But Burner Does Not Ignite (Gas Models)

Steps for when the igniter glows but the burner fails to ignite in gas dryers.

Heater Assembly or Burner Shuts Off Prematurely

Diagnosing premature shut-off of the dryer's heating components.

Heater Assembly or Burner Repeatedly Cycles Off on Limit Thermostat

Troubleshooting for heating system cycling due to limit thermostat issues.

Section 6 Test Procedures

Related product manuals