EasyManua.ls Logo

ALLIANCE FWN311SP301NW10 User Manual

ALLIANCE FWN311SP301NW10
76 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Troubleshooting
www.alliancelaundry.com
Part No. 201143R6
October 2015
W001C
Home Automatic
Washers
Refer to Page 6 for Model Numbers

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the ALLIANCE FWN311SP301NW10 and is the answer not in the manual?

ALLIANCE FWN311SP301NW10 Specifications

General IconGeneral
ModelFWN311SP301NW10
Washer TypeFront Load
Capacity11 kg
ColorWhite
Energy EfficiencyA+++
Weight75 kg
Water Consumption50 L per cycle
Delay StartYes
Child LockYes
DisplayLED

Summary

Section 1 - Safety Information

Section 3 - General Troubleshooting

No Hot Water

Diagnostic flowchart for issues related to the absence of hot water supply.

No Cold Water

Diagnostic flowchart for issues related to the absence of cold water supply.

Water Fill Does Not Stop At Proper Level

Flowchart to diagnose and resolve issues with water filling beyond the set level.

Motor Does Not Run

Diagnostic flowchart to identify why the washer motor is not operating.

No Agitation

Troubleshooting guide for when the agitator fails to move during the cycle.

Slow Spin

Diagnostic flowchart for a washer that is not spinning at the correct speed.

No Spin

Troubleshooting guide for a washer that fails to spin at all.

Washer Stops In Cycle; Quits After A Couple Loads; Is Intermittent

Troubleshooting for intermittent operational failures or stopping mid-cycle.

Washer Is Locked Up Or Binding

Diagnostic flowchart for a washer that is mechanically locked or binding.

Outer Tub Does Not Empty

Troubleshooting for issues where the outer tub fails to drain.

Excessive Vibration

Diagnostic flowchart for excessive vibration during washer operation.

Water Leaking From Outer Tub

Troubleshooting guide for water leaks originating from the outer tub.

Section 4 - Control Troubleshooting

Washer Will Not Fill (Pressure Switch Diagnostic)

Flowchart for diagnosing why the washer fails to fill, focusing on the pressure switch.

Washer Will Not Fill (Mixing Valve Diagnostic)

Flowchart for diagnosing why the washer fails to fill, focusing on the mixing valve.

Washer Over Fills (Pressure Switch Open)

Diagnostic steps for a washer that overfills, related to the pressure switch.

Section 6 - Test Procedures

Related product manuals