ALLIANCE SCL020WT User Manual

Troubleshooting
Washer-Extractors
Cabinet Hardmount
Refer to Page 8 for Model Identification
Original Instructions
Keep These Instructions for Future Reference.
CAUTION: Read the instructions before using the machine.
(If this machine changes ownership, this manual must accompany machine.)
www.alliancelaundry.com
Part No. F8677701EN
June 2019

ALLIANCE SCL020WT Specifications

General

Brand	ALLIANCE
Model	SCL020WT
Category	Washer
Language	English

Summary

Washer-Extractor Safety Information

Understanding Safety Message Symbols

Explains DANGER, WARNING, CAUTION symbols and their meanings for operator safety.

Essential Washer Safety Precautions

Covers crucial safety instructions for installation and operation of the washer.

Operator Safety Guidelines

Provides daily maintenance checks and safe operation practices for users.

Washer-Extractor Introduction and Setup

Washer-Extractor Model Identification

Lists applicable model numbers for the information provided in this manual.

Delivery Inspection Procedures

Instructions for visually inspecting the unit for shipping damage upon delivery.

Ordering Replacement Parts

Information on how to obtain literature or replacement parts for the machine.

Customer Service and Technical Support

Contact details for technical assistance and authorized parts distributors.

Washer-Extractor Theory of Operation

Machine Starting and Door Lock

Explains the initial cycle start process and the function of the door lock.

Water Fill Process

Details how water enters the machine and is regulated by the water level sensor.

Wash Cycle Operation

Describes the tumbling action of laundry within the wash basket.

Drain and Extract Cycles

Explains the gravity drain system and the high-speed extract function.

Troubleshooting Washer Errors

Troubleshooting: No Display

Flowchart for diagnosing and resolving a missing display on the control panel.

Troubleshooting: No Power to I/O Board (B Voltage)

Diagnosing lack of power to the I/O board for B voltage configurations.

Troubleshooting: Input/Output Board Communication Error E Co

Steps to resolve communication errors between I/O and front-end control boards.

Troubleshooting: Close Door Error CLoSE door

Diagnosing and fixing errors related to the door not closing properly.

Troubleshooting: Drive Board Communication Error E d Co

Resolving communication issues between the drive board and control system.

Troubleshooting: No Motor Rotation

Steps to diagnose why the motor is not rotating during operation.

Troubleshooting: No Water Flow Error E nFLo (No Fill)

Diagnosing issues when no water is entering the tub during the fill phase.

Troubleshooting: Heat Error E Ht (Steam Heat)

Steps to diagnose and resolve errors related to steam heating.

Troubleshooting: Excessive Vibration and/or Noise During Spin

Identifying causes and solutions for excessive vibration or noise during spin.

Troubleshooting: Abnormal Operation

Diagnosing general operational issues like water level or coast time anomalies.

Troubleshooting: Locked Rotor Error E d 34

Diagnosing and resolving locked rotor errors on the motor.