To Next PageTo Next Page
Need help?Do you have a question about the ALLIANCE SWNNC2HP115TW01 and is the answer not in the manual?
Options for setting vend prices for different cycles and modifiers.
Setting vend prices for Special Vend 1, from #7 to #9.
Adjusting wash, rinse, and spin times for standard cycles.
Options for OPL mode, delayed start, and display power save.
Visual guide for programming vend prices and coin values.
Visual guide for programming error and fill error parameters.
Visual guide for drain, water leak, and overflow settings.
Visual guide for setting clock and daylight savings parameters.
Visual guide for programming Special Vend 1 prices and modifiers.
Visual guide for Special Vend days enable and cycle modifier programming.
Visual guide for cycle parameters and low power/auto-shutdown settings.
Visual guide for IR access, diagnostics, OPL, and other advanced options.
Instructions for setting vend prices #1 through #4 for specific cycles.
Instructions for setting vend prices #5 through #8 for specific cycles.
Setting vend price #9 and modifier adder values.
Setting numerical values for coin 1 and coin 2 inputs.
Programming start pulse value and mode for payment systems.
Configuring when signals are active for outputs.
Setting the default cycle the machine enters in Ready Mode.
Programming when audible signals will sound during operation.
Programming a unique number for wired or wireless communication.
Turning on or off specific error codes in the control.
Configuring coin error parameters and fill error settings.
Configuring water leak, slow drain, and overflow error parameters.
Setting the control's internal clock to the correct time and date.
Adjusting the control's clock for daylight saving time.
Setting the minute for Special Vend 1 to begin.
Setting the hour for Special Vend 1 to begin.
Setting the date of the month for Special Vend 1 to begin.
Setting the year for Special Vend 1 to begin.
Setting vend prices #1, #2, and #3 for specific cycles.
Setting vend prices #6, #7, #8, and #9 for specific cycles.
Setting the default cycle modifier for Ready Mode.
General