To Next PageTo Next Page
Need help?Do you have a question about the ALLIANCE HWNNE2HP115CW01 and is the answer not in the manual?
General| Brand | Alliance |
|---|---|
| Model | HWNNE2HP115CW01 |
| Type | Washer |
| Phase | 1 |
| Frequency | 60 Hz |
| Washer Type | Front Load |
Explains the advanced programmable computer control system.
Defines key terms and abbreviations used throughout the manual.
How the control handles power interruptions and saves cycle status.
Outlines communication via Infra-red, Serial Card Reader, and Network.
Explains the function of Cycle, Temp, and Modifier pads.
Explains the purpose and status of LEDs on the control panel.
Describes the use of 7-Segment Digits for time, price, and error display.
Details modes like Ready, Partial Vend, Start, and End of Cycle.
Explains cycle progression and available audio signals.
How lid actions affect cycles and how to change cycles mid-cycle.
Covers Delayed Start, Overflow, Lockout, Shutdown, and Power Failure modes.
Overview of programming the control via keypad for various options.
Procedures for collecting audit data and running diagnostic tests.
Covers features like Rapid Advance, Clear Vend, Break-in Alarm, Special Vend, OPL, Drop-Off.
Lists and describes all programmable options available for the control.
Setting vend prices for different cycles and modifiers.
Configuring default cycles, audio signals, time/date, and daylight savings.
Methods to enter, read, and exit audit data.
Steps to enter Manual Reset mode to restore factory defaults.
Procedures for running diagnostic tests on machine components.
Lists possible error codes, their descriptions, and corrective actions.
How to advance cycles quickly and clear vend price.
How the control communicates via Infra-red, Card Reader, and Network.
Details the factory default cycle steps and times.
