Manually Installing a Network Adapter Driver
48
8. If you are using a driver installation disk, do the following:
a. Insert the driver installation disk into the floppy disk drive.
b. Select Floppy disk drives.
c. Select Specify a location.
d. Select Next.
e. In the Specify a Location field, enter A:\. The adapter driver is
stored in the root directory on the disk.
The Found New Hardware Wizard starts to search for the
appropriate adapter driver file. After an adapter driver has been
found, the window shown in Figure 25 is displayed.
f. Proceed to Step 9.
9. Select Next.
The window in Figure 26 is displayed.
Figure 26 Digital Signature Not Found Window
10. Select Yes.
To Next Page
Loading...