Electrical Safety and Installation Requirments
STANDARDS
: This product meets the following standards
RFI Emission EN55022 Class A
WARNING
: In a domestic environment this product may cause radio interference in which case the user may be required
to take adequate measures.
Immunity EN50082-1
These products have been safety tested by UL to Standard UL 1950, CSA to CSA 950 and by TUV to EN60950.
SAFETY
ELECTRICAL NOTICES
WARNING:
ELECTRIC SHOCK HAZARD
To prevent ELECTRIC shock , do not remove cover. No user-serviceable parts inside. This unit contains HAZARDOUS
VOLTAGES and should only be opened by a trained and qualified technician. To avoid the possibility of ELECTRIC SHOCK
disconnect electric power to the product before connecting or disconnecting the LAN cables.
LIGHTNING DANGER
DANGER:
DO NOT WORK on equipment or CABLES during periods of LIGHTNING ACTIVITY.
CAUTION
: POWER CORD IS USED AS A DISCONNECTION DEVICE. TO DE-ENERGISE EQUIPMENT disconnect the power
cord.
INSTALLATION
ELECTRICAL—AUTO VOLTAGE ADJUSTMENT
This product will automatically adjust to any voltage between the ranges shown on the label.
ELECTRICAL—TYPE CLASS 1 EQUIPMENT
THIS EQUIPMENT MUST BE EARTHED. Power plug must be connected to a properly wired earth ground socket outlet. An
improperly wired socket outlet could place hazardous voltages on accessible metal parts.
ELECTRICAL—CORD NOTICE
Use power cord, maximum 4.5 meters long, rated 6 amp minimum, 250V, made of HAR cordage molded IEC 320
connector on one end and on the other end a plug approved by the country of end use.
CAUTION
: Air vents must not be blocked and must have free access to the room ambient air for cooling.
OPERATING TEMPERATURE
This product is designed for a maximum ambient temperature of 40 degrees C.
ALL COUNTRIES:
Install product in accordance with local and National Electrical Codes.
U.S. Federal Communications
RADIATED ENERGY
Note: This equipment has been tested and found to comply with the limits for a Class A digital device pursuant to Part
15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and , if not installed and used in accordance with this instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
Note: Modifications or changes not expressly approved of by the manufacturer or the FCC, can void your right to
operate this equipment.
Canadian Department of Communications
This Class A digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Cet appareil numérique de la classe A respecte toutes les exigences du Règlement sur le matériel brouilleur du
Canada.
i
MR11x/MR12x.4Web Page 2 Monday, February 24, 1997 11:33 AM
To Next Page
Loading...
