FS750 Series Fast Ethernet Switches Installation Guide
41
Powering On the Switch
To power on the switch, perform the following procedure:
1. Plug the power cord into the AC power connector on the back of the
switch, as shown in Figure 13.
Figure 13. Plugging in the AC Power Cord
2. Plug the other end of the power cord into a wall outlet.
Power cord is used as a disconnection device. To de-energize
equipment, disconnect the power cord. E3
Pluggable Equipment. The socket outlet shall be installed near the
equipment and shall be easily accessible. E5
3. Verify that the POWER LED is green. If the LED is OFF, see Chapter
3, “Troubleshooting” on page 43.
4. If your switch is an AT-FS750/28PS model, verify the SYS LED is
green.
The switch is now powered on and ready for network operations. For
information on how to manage the switch, see the FS750 Series Web
Management User’s Guide.
To Next Page
Loading...
