Bitmain Miner Status
Bitmain Miner Status
Bitmain Miner Status The Miner Status module reads the values of the Bitmain Antminer
D3/L3+/S9/A3 and displays the available sensors. In our module you can activate the desired
sensors, which are then created as a sensor on the overview page. Of course, the sensors can then
be displayed and controlled individually, like all other sensors, in the subpages and in the
corresponding rules. An e-mail address for alarm messages can also be created in the module, which
then automatically creates a rule under "Functions - Actions".
Prerequisite:
Currently supported are Antminer D3, Antminer L3+, Antminer S9 & Antminer A3 ALLNET MSR
headquarters e.g. ALL3419 / ALL3500 / ALL3505 / ALL4500 & / ALL5000 is required Platform
independent
To Next Page