Hostname Here you give your MSR a name with which it is registered in the network. Only1.
the following characters are valid: a-z, A-Z, 1-9 and hyphen (not to be used at the beginning or
at the end). No special characters and spaces may be used. Maximum 15 characters are
possible.
Domain (only for static address assignment) To integrate the device into a domain, enter the2.
domain name here.
IP Address Settings When selecting "DHCP" the MSR will use an IP setting assigned by the3.
DHCP server, points 3. – 7. do not apply. In "Statistic" (Default), you must manually assign the
address.
IP AddressIP address of the MSR DETAILED in the local network (Please make sure that4.
you do not give an IP address twice (ask your network administrator if necessary).
NETMASK Subnet Mask, Default: 255.255.255.0. The setting must match your network, if5.
necessary ask your network administrator or use the same subnet mask set on your router's
LAN port.
DEFAULT GATEWAY Enter the default gateway here, usually the IP address of your router.6.
Erster DNS Enter the address of your DNS server here. In home networking, this is usually7.
the IP address of your router.
Second DNS Default setting is 8.8.8.8 Please only change if there is a second DNS server in8.
your internal network.
Confirm with "Enter Save" after changing the parameters. The MSR DETERMINATION
automatically restarts. After about 90 seconds, the MSR DETERMINATION should be accessible
with the new parameters.
Wi-Fi setting
To Next Page
Loading...