14
AC OPERATORS MANUAL
Low Power Wiring
Signal Wiring
Signal wires should be keep as short as practical. Care should be
taken to protect the wires from sharp edges and rubbing. Consider
the use of split loom or braided wire sheathing. Fasten bundles
securely to framework. Do not route the signal wires together in
the same bundle with power wires.
Temp Sensor
Induction motors come with a two wire temp sensor which
the controller uses to monitor internal temps during operation.
On DC conversions the temp sensor will run through the same
harness connector as your speed sensor.
To Next Page
Loading...
