Alltrax AC1 - Wire Harness Pinout; PDS MOLEX connectors

22
AC OPERATORS MANUAL
WIRE HARNESS PINOUT
PDS MOLEX connectors
Flat 4 pin
Square 4 pin
Rectangle 10 pin
The E-Z-GO PDS connects with 4 harnesses. The three used with
the AC1 conversion are showed in the picture above. The missing
connector is used for the speed sensor on the stock vehicle. With the
Alltrax AC1 conversion you will be using a new speed sensor and
tempsensorwirecomingdirectlyothemotor(inmostcases).