Allworx
®
Verge™ IP Phone Series User Guide
Page 14 866.ALLWORX * +1 585 421 3850
www.allworx.com
Version: T Revised: February 14, 2019
2.8 Sleep Mode
A Verge IP phone time-out state after remaining idle for a specified period (default is 2 minutes). The
Verge IP phone displays the date/time, number of missed calls and new messages, caller ID name /
number, and the Allworx logo. The attached sidecars go blank during Sleep Mode. If the Verge IP
phone does not register with the server while in sleep mode, a red icon ( ) displays on the screen. If
this happens, contact the Allworx Server Administrator as the Verge IP phone is unable to place or
receive calls.
To exit the Sleep Mode, press any Verge IP phone button to display the Idle screen, except for the
following buttons:
• Contacts*, Messages, or Presence function button opens the respective screen.
• Intercom function button accesses the Intercom appearance.
• Headset or speaker phone function button, keypad button or lifting the handset accesses
the call appearance programmable button and begins dialing the phone number.
• Volume Control button opens the Ringer Volume screen.
* If the Personal Contacts is set to Restricted (Settings > Phone Preferences > Personal Contacts),
Allworx users cannot immediately access the Personal Contacts. To unlock the Personal Contacts on the
Idle screen, tap the More Function button ( ) > (locked contacts) and enter the assigned credentials.
Press the Done soft key when complete. The Verge IP phone returns to the Idle screen, and the Allworx
user can access the Personal Contacts. The Personal Contacts remain available until the Verge IP phone
enters the Sleep mode.
Verge IP phone Sleep Mode screen example:
To Next Page
