PAGE 106 ALMAC s.r.l.
ATTENTION: BE CAREFUL WHEN THE TRACK FALLS TO THE GROUND.
1. Lift the track at the lower centre line;
2. Pull the track (outwards), prying between the track itself and the idler
wheel;
3. To install the new track, proceed as indicated in the previous points, but
in reverse order;
4. The track is correctly tensioned by using the tensioning kit, pumping
grease until the pressure indicated on the technical data sheet has been
reached.
WARNING: before performing the tensioning of the track, check the technical
data sheet for the correct pressure expressed in bar.
To Next Page
Loading...
