PAGE 51 ALMAC s.r.l.
3.6 Blackout safety devices
3.6.1 External power source 230V or 110V
On the machine there is a plug to power the AC electric motor or the battery
chargers to recharge the traction batteries. For safety reasons, a device is
installed so as to cut-out the electricity supply in case of over-voltage and
"differential circuit breaker" dispersions (1).
To access the device, it is necessary to unscrew the dedicated knobs on the
cover itself, removing the transparent protection panel (2) and open the
electrical box cover. When finished, replace the guard that was previously
removed and thoroughly tighten the knobs.
3.6.2 12V-48V system
On the right side of the machine is the "battery disconnector" (3) that physically
disconnects the 48V power line coming from the battery and supplies the various
users, and the 12V line of electronic power supply and utilities.
It is recommended to operate this device at the end of the work day, to prevent
draining the batteries.
Inside the frame there are also safety fuses to protect the 12V electric devices.
To Next Page
Loading...
