PAGE 71 ALMAC s.r.l.
4.6 Stopping the machine
4.6.1 Normal stop
During normal machine use, releasing the TRANSLATION joysticks (9 and 10)
stops the movement. Each track installed has a braking system that prevents the
machine from moving unless hydraulic pressure is exercised to disengage it.
Deactivation of the machine must take place in these ways:
• Stop the machine in the manner described above;
• Position the key selector (1) on the ground controls in the sx position and
then remove the key;
• Disconnect the battery from the battery switch (2);
• Place the console in the appropriate compartment (3).
To Next Page
Loading...
