Almaco Seed Spector LRX - Page 35

SEED SPECTOR LRX MANUAL
27
$Y – DEVICE SCAN TIME
Syntax: $Y(D)(V)
Where:
(D) is the device (channel).
(V) is a desired scan time value.
This command sets the SCAN time for a specific channel. This is the time base
used by the SS LRX to read the A/D converter:
Response: Y(D) = [current value > new value]<CR><LF>
$Z – RESET RELAY
Syntax: $Z(N)
Where:
(N) is the relay number
This command resets or opens the specified relay.
NOTE: See $S Command for more information
Response: None