9
Subject to change without notice | 83053700lUK | ait-deutschland GmbH
NOTE
Variant 2 is only possible if the expansion
board (purchasable accessories) is installed
in the heating and heat pump controller.
Comfort board operating manual
13 Care of the unit
The outer surfaces of the unit can be cleaned with a
damp cloth and standard cleaning products.
Do not use cleaning or care products that contain
abrasives, acids and/or chlorine. Such products would
destroy the surfaces and could also damage the
technical components of the unit.
14 Scope of delivery
Example of scope of delivery:
1 Heat pump = complete indoor unit
2 Facing panels
*)
placed to the side
3 Transport frame
4 Prole rails
5 Insulation panel, which is then pushed under
the baseplate (sound insulation)
6 Facing panels placed to the side (5 panels)
7 Extra box with accessories (indoors)
8 Pre-tted adjustable feet (4)
9 Spacer blocks (4), which can be unscrewed
after installation
*)
a total of 5 panels
1. Check the delivery for outwardly visible signs of
damage.
2. Check that nothing is missing from the scope of
supply.
Any defects or incorrect deliveries must be
reported immediately.
NOTE
Note the unit model.
“Technical data / scope of delivery“, from
page 22
14.1 Main components
1 condenser
2 compressor
3 evaporator
To Next Page
Loading...
Need help?
General
