Alpine 35278 - Page 7

POWER MOSFET DC-TO-DC SWITCHING MODE POWER SUPPLY
Provides excellent power output throughout the audio bandwidth (20Hz to 20kHz).
lts soft clipping characteristics ensure superb transient response and musicality.
INDEPENDENT, CONTINUOUSLY ADJUSTABLE GAIN CONTROLS FOR
CH1/2 AND CH3/4
Allow different level settings for both pairs of channels.
GOLD-PLATED RCA INPUT CONNECTORS
For most accurate signal transmission and lowest possible loss. Gold-plated
terminals are immune to signal deterioration caused by corrosion in the connec-
tors that can develop over time.
GOLD-PLATED, SCREW-DOWN POWER AND SPEAKER TERMINALS
For high definition, minimum loss power transfer and oxidization resistance.
FULLY DISCRETE, COMPLEMENTARY OUTPUT CIRCUITRY
For excellent reliability, superb sonic performance and high current capability for
accurate transient response.
HIGH PERFORMANCE, LOW NOISE, AUDIOPHILE QUALITY ACTIVE AND
PASSIVE
COMPONENTS
For best possible performance and consistency from unit to unit.
THIRD-ORDER, (18 dB PER OCTAVE) CAPACITIVE/INDUCTIVE POWER
SUPPLY INPUT AND OUTPUT FILTERING
Prevents radio frequency interference (RFI) and immunity to system noises (such
as alternator whine).
S.T.A.R. CIRCUITRY
The Alpine-developed Signal Transit for Accurate Response circuit topology
improves sonic properties by reducing interaction between different sections of
the circuitry.
EXTRA HEAVY DUTY CONSTRUCTION
Glass-epoxy printed circuit boards and separate high current power transfer bus-
bars for primary voltage and ground connections inside the amplifier.
STATUS MONITOR
This indicator illuminates in green when the amplifier is on and operational. This
light will turn orange if any internal protection circuitry is activated. In case of an
installation problem, the STATUS MONITOR can aid in troubleshooting the
system.