Alpine 7525R - Page 13

Preset Memory Programming
Ea i as
Or
Follow the instructions below to program stations into preset memory:
Select the tuning band (FM1, FM2, MW or LW) with the BAND button @.
Tune in your desired station using manual or auto seek tuning.
Press the Preset button number 1 49 for more than 2 seconds.
The preset indicator 8) and the dot matrix display @ will begin to blink. Press that
Preset button again while the display is blinking (within 5 seconds).
The frequency you selected will be placed into preset memory number 1 and will
appear in the display.
NOTE:
lf a preset memory has already been set in the same address, it will be cleared and
the new station will be memorized.
Follow steps 2 — 4 for the remaining presets (2 — 6). Use this procedure for FM1,
FM2, MW and LW.
Auto Memory Preset
d,
Select the desired tuning band (FM1, FM2, MW or LW) with the BAND button @9. The
Band indicator shows your selection.
NOTE:
The auto memory preset procedure is allowed in the D.A.P. mode.
Press the A. ME button @ for over 2 seconds.
The tuner will automatically seek the 6 strongest stations in the selected band and
memorize them in order of their signal strength. These stations are automatically
placed in the preset memory with the strongest station in preset No. 1 and the 6th
strongest station in preset No. 6. When seeking stations, the tuner first seeks in the
local tuning mode. If less than 6 stations are memorized, the tuner seeks again in the
distance (DX) mode.
After finishing the auto memory preset, the tuner goes to the station placed in preset
memory No. 1. If no stations are memorized, It returns to the original station you were
listening to before the auto memory preset procedure began.
Preset Tuning
After the preset stations have been memorized, you can tune in your desired station
(within the band displayed) with one touch of a button.
le
2:
<F
Select the tuning band (FM1, FM2, MW or LW) with the BAND button @9.
Press any one of the Preset buttons (4) — @) and the number of that preset will
appear in the preset channel indicator @4.
The frequency of the station placed in the selected preset location will appear in the
display.
13
a aE ON Ng les do PN Bie A og ght Me ae