Alpine 7525R - Radio Operation

@ RADIO OPERATION
Tuning Band Selection
Press
the
BAND
button
@
to
select
the
desired
tuning
band.
The
Band
indicator
shows
your
selection.
Local/Distance
(DX)
Seek
Sensitivity
for
FM,
MW
and
LW
You
can
select
the
radio
seek
sensitivity
(local
or
distance
(DX)),
by
pressing
the
DX
(distance)
button
@3.
In
the
local
mode,
with
no
DX
indicator
6,
the
radio
tunes
in
only
strong
stations
(stations
C,
F,
H
and
L
in the
illustration
below).
in
the
distance
mode,
with
DX
indicator
62,
the
radio
tunes
in
both
strong
and
weak
stations
(all
stations
from
A
to
M
in
the
illustration).
Signal Strength
Station Frequencies
FM Stereo/Monaural Switching (7525R only)
You
can
select
between
the
auto
switching
or
monaural
only
modes
for
FM
reception
by
pressing
the
MONO
button
@.
In
the
auto
switching
mode,
you
can
receive
stereo
broadcasts
in
stereo
and
monaural
broadcasts
in
MONO.
In
the
monaural
mode,
you
will
receive
the
broadcast
in
monaural
only,
even
if
the
broadcast
is
in
stereo.
The
monaural
only
mode
quiets
the
noisy
stereo
signal
of
weaker
broadcasts.
The
ST
indicator
@
will
not
appear
while
the
monaural
mode
is
selected.
Manual and Auto Seek Tuning
Stations can be tuned in using the procedures described below.
1.
Select
the
tuning
band
(FM1,
FM2,
MW
or
LW)
with
the
BAND
button
2.
The
Band
indicator shows your selection.
an —> F2 <> MW ee
2. Decreasing the frequency:
The frequency is decreased by one step each time the DN switch © is pressed.
By pressing and holding the switch for at least 0.5 seconds, the unit will automatically
tune the first station it finds in the direction of decreasing frequency.
3. Increasing the frequency:
The frequency is increased by one step each time the UP switch @ is pressed.
By pressing and holding the switch for at least 0.5 seconds, the unit will automatically
tune to the first station it finds in the direction of increasing frequency.
12