Alpine 7525R - Basic Operation

@ BASIC OPERATION
initial System Start
When operating the system for the first time after installation or after the vehicle's
battery has been disconnected and reconnected, set the volume level to its minimum,
then carefully press the Reset switch @ with a sharp pencil or any other pointed object.
How to adjust the volume and tone (Refer to the diagram in next page.)
1. Turn On the system by pressing the PWR switch 4 or any other button
(other than Eject © or Reset @).
2. Press the Audio MODE Select switch @ to select each adjusting mode.
es —> BASS — BAL -—> FAD Sainte]
Each time this switch is pressed, the mode changes. The mode is indicated in the
display. The mode indicator changes as each mode is selected.
3. Once the desired mode appears in the display, use the Audio Controller 0 to make
your adjustment. The Audio Control Up indicator 82 flashes when turned clockwise and
the Down indicator 86 flashes when turned counterclockwise.
Power Off
Press the PWR button 4 to turn the unit Off.
Loudness
1. Press the LOUD button @ for more than 2 seconds to activate the loudness function.
2. Press the LOUD button @ for more than 2 seconds again to defeat this feature.
Mode Switching of the 7525R/7524R
1. Radio Mode
Press the BAND button @ to put the unit into the radio mode. The Band indicator
(F1, F2 or MW/LW) will appear in the display.
2. Cassette Player Mode
Press the TAPE button @ to put the unit into the cassette player mode.
3. CD Shuttle Mode
Press the DISC button @ to put the unit into the CD mode.
Five Modes Setting Function
This unit allows setting of five modes shown below. For further details, refer to the
description on each mode.
Preset No. 1: FM level switching.
Preset No. 2: Sound volume setting during reception of traffic information.
Preset No. 3: Switching of automatic tracing function. (A.P.1. 1/A.P.1. 2/PS ONLY)
Preset No. 4: Regional program on/off switching.
Preset No. 5: Built-in lighting switch function (green/amber).