Alpine 7525R - Tape Player Operation

@ TAPE PLAYER OPERATION
Turn the unit On and press the TAPE ( »/IE) button @8 to access the tape mode.
Dolby* B/C Noise Reduction
Before playing a cassette tape, check to see if it is encoded with Dolby B or C noise
reduction. Press the Dolby NR button 49 when playing a Dolby NR encoded tape.
Press the Dolby NR button @ to select Dolby NR mode. The Dolby NR indicator 8? and
the B @9 or C @ indicator shows your selection. The Dolby NR mode changes each time
the button is pressed.
OFF
—{ptie }—{De}—{_—}-
NOTE:
Only Dolby B is offered on the 7524R.
Cassette Loading
1. Insert a prerecorded cassette tape into the cassette loading slot ® with the open side
facing to your right.
2. If the cassette tape is not completely loaded into the deck, lightly press the cassette
into the slot.
Metal (MTL) Indicator
Metal or CrO, cassette tapes having an open detection hole will automatically be
detected, in which case the MTL indicator @ in the display comes on and the playback
equalization is automatically set to 7Ousec.
Eject
Press the Eject button © to eject the cassette from the tape mechanism.
Pause
To temporarily stop playback, press the TAPE ( b/i) button 2). To resume playback,
press the same button again.
Playback
1. Insert a prerecorded cassette tape with the open side facing right. The playback
begins immediately.
2. \|facassette tape is already loaded in the unit, press the TAPE ( P/HI ) button @8 to
start playback.
3. To stop tape play, press the Eject button © or turn the power Off with the PWR
switch 0.
NOTE:
Push the DISP button @6 with the tape or CD played in the A.P.I|. or T. INFO mode, and
the unit will be set to the TUNER mode and the tuning is possible.
15