19-EN
Indication for CD Player
HI TEMP
• Protective circuit is activated due to high temperature.
- The indicator will disappear when the temperature returns to
within operation range.
NO DISC
• No CD is inserted.
- Insert a CD.
• Although a disc is inserted, “NO DISC” is displayed and the
unit does not start to play or eject the disc.
- Remove the disc by following these steps:
Press the c button again for at least 2 seconds.
If the disc still does not eject, consult your Alpine dealer.
ERROR
• Mechanism error.
1) Press the c button and eject the CD.
If not ejecting, consult your Alpine dealer.
2) When the error indication remains after ejecting, press the
c button again.
If the error indication still does not turn off after pressing
the c button for a few times, consult your Alpine dealer.
• When “ERROR” is displayed:
If that the disc cannot be ejected by pressing c, press the RESET
switch (refer to page 5) and press c again.
If the disc still cannot be ejected, consult your Alpine dealer.
• The disc is not compatible with the unit.
- Insert a disc which is compatible with the unit.
PROTECT (CDE-9845 only)
• A copy-protected WMA file was played back.
- You can only play back non-copy-protected files.
UNSUPORT (CDE-9845 only)
• The disc is not written in a MP3/WMA supported format.
- Use a disc written at the MP3/WMA supported format.
UNSUPORT (CDE-9843 only)
• The disc is not written in a MP3 supported format.
- Use a disc written at the MP3 supported format.
Specifications
FM TUNER SECTION
Tuning Range 87.7 – 107.9 MHz**
Mono Usable Sensitivity 9.3 dBf (0.8 µV/75 ohms)
50 dB Quieting Sensitivity 13.5 dBf (1.3 µV/75 ohms)
Alternate Channel Selectivity 80 dB
Signal-to-Noise Ratio 65 dB
Stereo Separation 35 dB
Capture Ratio 2.0 dB
AM TUNER SECTION
Tuning Range 530 – 1,710 kHz**
Sensitivity (IEC Standard) 22.5 µV/27 dB
CD PLAYER SECTION
Frequency Response 5 – 20,000 Hz (±1 dB)
Wow & Flutter (% WRMS) Below measurable limits
Total Harmonic Distortion 0.008% (at 1 kHz)
Dynamic Range 95 dB (at 1 kHz)
Signal-to-Noise Ratio 105 dB
Channel Separation 85 dB (at 1 kHz)
PICKUP
Wave length 795 nm
Laser power CLASS I
GENERAL
Power Requirement 14.4 V DC
(11–16 V allowable)
Power Output 16 W RMS × 4*
* Primary amplifier ratings per CEA-2006 Standard
• Power output: measured at 4 Ohms and ≤ 1% THD+N
• S/N: 80 dBA (reference: 1 W into 4 Ohms)
Bass +20 dB/-14 dB at 100 kHz
Treble ±14 dB at 10 kHz
Maximum Pre-Output Voltage 2 V/10 k ohms
Weight 1.6 kg (3 lbs. 8 oz)
CHASSIS SIZE
Width 178 mm (7")
Height 50 mm (2")
Depth 160 mm (6-1/4")
NOSEPIECE SIZE
Width 170 mm (6-11/16")
Height 46 mm (1-13/16")
Depth 18 mm (11/16")
• Due to continuous product improvement, specifications and design
are subject to change without notice.
** CDE-9845/CDE-9843:
When you choose “AREA 2” in the section “Changing the Radio
Frequencies for each Country” (page 6), the tuning range is as
follows.
FM : 87.5 - 108.0 MHz
AM : 531 - 1,602 kHz
To Next Page
Loading...
