DVA-5210
No. Symbol I/O Terminal Description
47
I
49
50 VDD - Power supply terminal.
51 TEST3
52 TEST2
53 TEST1
54 TEST0
55 FG O FG signal input terminal.
56 FEPSENS O AN8709 SENSE signal terminal.
57 CPUDTIO O AN8709 CPUDTIN signal terminal.
58 SCK O AN8709 SCK signal terminal.
59 (SBD) I YDC Flash writer SBD signal terminal.
60 (SBO) I YDC Flash writer SBO signal terminal.
61 (SBT) I YDC Flash writer SBT signal terminal.
62 UDRX I UART receiving signal terminal. (DEBUG side : not used)
63 UDTX O UART transmitting signal terminal. (DEBUG side)
64 FEPRES O AN8709 RESETsignal terminal.
65 UCRX I UART receiving signal terminal. (COMMAND side)
66 UCTX O UART transmitting signal terminal. (COMMAND side)
67 NC - No connect terminal.
68 VDD - Power supply terminal.
69 VSS - GND potential supply terminal.
70 AVSS - ANALOG GND potential supply terminal.
71 Vref- - ANALOG standard (-) voltage terminal.
72 HALFSENS I VHALF power supply terminal.
73 SLEDSENS I SLED control signal input terminal.
74 HITEMP I High-temperature signal input terminal.
75 LOTEMP I Low-temperature signal input terminal.
76
I
78
79 MODE_SEL I
Discrimination input terminal of correspondence both 8cm Disc and CD
(connected pull-up)/or not (connected pull-down).
80 SDA I/O E2P-ROM SDA signal terminal.
81 SCL O E2P-ROM SCL signal terminal.
82 DCFLTCNT O FEP filter switching terminal.
83 HFMCNT O High-frequency upon another control output terminal. (connected pull-down)
84 DRVCNT1 O Driver logic control output-1 terminal. (connected pull-down by internal IC)
85 DRVCNT2 O Driver logic control output-2 terminal. (connected pull-down by internal IC)
86 VREF+ - Analog standard (+) voltage terminal.
87 AVDD - Analog power supply terminal.
88 PLAYA O SLED-2 driving control D/A output-A terminal.
89 PLAYB O 4 SLED-2 driving control D/A output-B terminal.
90 LOADOUT O LOAD MOTOR control D/A output terminal.
91
I
93
NC - No connect terminal.
NC - No connect terminal.
- No connect terminal.NC
O TEST terminal.
To Next Page
Loading...
