Alpine EZi-DAB-ONE - Switching Your Ezi-DAB-ONE on for the First Time; Switching Your Ezi-DAB-ONE on and off

Switching your EZi-DAB-ONE on for the first time
After you've installed your EZi-DAB-ONE, switch it on to finish setting it up.
1. Turn on your vehicle’s ignition to make sure your EZi-DAB-ONE is switched on.
2. Press and to change the display language, then press Select to choose it.
3. Press and Select to choose how to connect your EZi-DAB-ONE to your vehicle.
•
If you've connected your EZi-DAB-ONE with the Line Out cable, choose 'Line out'. Then press and Select to
choose 'Normal gain'. If you later find that audio is distorted, you can change the gain setting. Read more on
page17.
•
If you're connecting your EZi-DAB-ONE by FM radio, choose ‘FM transmit' and then choose an FM frequency.
Ensure a radio station isn't using the frequency you choose.
Tune your vehicle’s audio system to the same FM frequency as your EZi-DAB-ONE. To easily find the FM
frequency in the future, save it as a preset on your vehicle’s audio system.
After you’ve chosen how to connect your EZi-DAB-ONE, it starts tuning to digital radio stations. When the autotune is
complete, you can start listening to digital radio.
Switching your EZi-DAB-ONE on and off
•
To switch on your EZi-DAB-ONE, press .
•
To put your EZi-DAB-ONE in standby and use less power, press and hold .
Note: By default, the controller automatically enters standby after 4hours. To change the delay, see page17.
13